Ip Filtering Screen; Mac Filtering Screen - ZyXEL Communications NBG2105 User Manual

14.5 IP Filtering Screen

Click Firewall > IP Filtering to apply filtering based on IP addresses.
Figure 63 Firewall > IP Filtering
The following table describes the labels in this screen.
Table 52 Firewall > IP Filtering
LABEL
Enable IP Filtering
Local IP Address
Protocol
Comment
Apply Changes
Reset
Current Filter Table
Local IP Address
Protocol
Comment
Select
Delete Selected
Delete All
Reset

14.6 MAC Filtering Screen

Click Firewall > MAC Filtering to apply filtering based on MAC addresses.
NBG2105 User's Guide
DESCRIPTION
Click this to apply filtering based on IP addresses.
Enter the source IP address of outgoing packets or the destination IP address of
incoming packets that this rule matches.
Select TCP to filter on TCP packets, UDP to filter on UDP packets or Both to filter on
both TCP and UDP packets.
Enter a description of this rule.
Click this to save changes back to the NBG2105.
Click this to begin configuring this screen afresh.
This shows the source IP address of outgoing packets or the destination IP address of
incoming packets that this rule matches.
This shows TCP for TCP port filtering, UDP for UDP port filtering or Both for TCP and
UDP port filtering.
Enter a description of this rule.
Click this to select this rule.
Click this to delete the selected rules.
Click this to delete all rules.
Click this to reset all selections.
Chapter 14 Firewall
101