ZyXEL Communications NBG2105 User Manual page 80

Chapter 11 Quality of Service (QoS)
The following table describes the labels in this screen.
Table 36 Network > QoS
LABEL
QoS Setup
Enable QoS
Upstream
bandwidth (Kbps)
Downstream
bandwidth (Kbps)
QoS Rule Setting
Address Type
Local IP Address
MAC Address
Mode
Upstream
Bandwidth (Kbps)
Downstream
Bandwidth (Kbps)
Apply Changes
Reset
Current QoS Rules Table
Local IP Address
MAC Address
Mode
Upstream
Bandwidth
Downstream
Bandwidth
Select
Delete Selected
Delete All
Reset
80
DESCRIPTION
Select this to enable QoS.
This shows the amount of upstream bandwidth for the WAN interface that you can
allocate using QoS.
The NBG2105 automatically sets this number to the WAN interface's actual upstream
transmission speed.
This shows the amount of downstream bandwidth for the WAN interface that you can
allocate using QoS.
The NBG2105 automatically sets this number to the WAN interface's actual downstream
transmission speed.
Select IP to configure a QoS rule to match the source IP address of outgoing packets or
the destination IP address of incoming packets.
Select MAC to configure a QoS rule to match the source MAC address of outgoing
frames or the destination MAC address of incoming frames.
Enter the source IP address of outgoing packets or the destination IP address of
incoming packets that this QoS rule matches.
Enter the source MAC address of outgoing packets or the destination MAC address of
incoming packets that this QoS rule matches.
Select the mode for this rule: Guaranteed minimum bandwidth or restricted
maximum bandwith.
Enter the maximum/guaranteed minimum bandwidth (according to the mode you
select) allowed for outgoing traffic that matches the IP address or MAC address you
specified.
Enter the maximum/guaranteed minimum bandwidth (according to the mode you
select) allowed for incoming traffic that matches the IP address or MAC address you
specified.
Click this to save changes back to the NBG2105.
Click this to begin configuring this screen afresh.
This shows the source IP address of outgoing packets or the destination IP address of
incoming packets that this QoS rule matches.
This shows the source MAC address of outgoing packets or the destination MAC address
of incoming packets that this QoS rule matches.
This shows the mode of this rule.
This shows the uplink bandwidth that this rule enforces according to the Mode.
This shows the downlink bandwidth that this rule enforces according to the Mode.
Click this to select this rule.
Click this to delete the selected rules.
Click this to delete all rules.
Click this to reset all selections.
NBG2105 User's Guide