Wiring Diagram - Pyle PLCDCS90M Owner's Manual

WIRING DIAGRAM

Note:
1.Make sure use a speaker with 4 ohm load impedance.
2.Do not make the auto antenna wire and ground touch each other.
When you want to play the CD changer, plug the CD changer DIN into
the socket of the back of the car audio unit.
CAUTION:
In order to protect the power IC from being burnt out during installation
of the car stereo, it is necessary to follow the steps below to connect the wires
during installation:
Step 1: Connect the ground wire (Black);
Step 2: Connect all speaker wires and power antenna wire (Blue):
Right speaker
Front speaker: White (+)
Rear speaker: Green (+)
-
-
White/Black (-)
Green/Black (-)
CD CHANGER DIN SOCKET
Left speaker
Gray (+)
Violet (+)
9
BLUE AUTO ANT
-
-
Gray/Black (-)
Violet/Black (-)