Introduction - Cisco Unified 7900 Series Release Notes

Introduction

Introduction
These release notes support the Cisco Unified IP Phones 7900 Series running SCCP and SIP Firmware Release
9.3(1)SR2.
The following table lists the Cisco Unified Communications Manager release and protocol compatibility for
the Cisco Unified IP Phones.
Table 1: Cisco Unified IP Phones, Cisco Unified Communications Manager, and firmware release compatibility
Cisco Unified IP Phone
Cisco Unified IP Phones 7906G, 7911G, 7941G,
7941G-GE, 7961G, 7961G-GE, 7970G, and
7971G-GE
Cisco Unified IP Phones 7906G, 7911G, 7941G,
7941G-GE, 7961G, 7961G-GE, 7970G, and
7971G-GE
Cisco Unified IP Phone 7931G
Cisco Unified IP Phone 7931G
Cisco Unified IP Phones 7942G, 7945G, 7962G,
7965G, and 7975G
Cisco Unified IP Phones 7942G, 7945G, 7962G,
7965G, and 7975G
Firmware Release 9.3(1)SR2 is designed and tested to interoperate with Cisco call control, most notably
Note
Cisco Unified Communications Manager Release 9.0(1). Although SIP firmware is IETF RFC 3261
compliant, it is not supported by Cisco TAC or Engineering for use with non-Cisco call control systems.
Cisco Unified IP Phone 7900 Series Release Notes for Firmware Release 9.3(1)SR2
2
Cisco Unified IP Phone 7900 Series Release Notes for Firmware Release 9.3(1)SR2
Protocol Cisco Unified Communications Manager
SCCP Cisco Unified Communications Manager
Release 6.0 and later
Cisco Unified CallManager Release 5.1, 5.0,
4.3, 4.2, 4.1, 4.0
Cisco CallManager Release 3.3
SIP Cisco Unified Communications Manager
Release 6.0 and later
Cisco Unified CallManager Release 5.1 and
5.0
SCCP Cisco Unified Communications Manager
Release 6.0, 6.1, 7.0 and later
SIP Cisco Unified Communications Manager
Release 7.0 and later
SCCP Cisco Unified Communications Manager
Release 6.x and later
Cisco Unified CallManager Release 5.1,
4.3(2)
SIP Cisco Unified Communications Manager
Release 6.x and later
Cisco Unified CallManager Release 5.1