Special Status Light/Tone Information - Microcom 405 Addendum

405 Addendum to 410 Operators Manual
1.3

SPECIAL STATUS LIGHT/TONE INFORMATION

The status light has different functions depending upon the mode of the printer. Table 1 shows
the relationship between the status light and the different modes.
Light Tone
Color
Green None
Green Double tone
before print
Red None
Flashing Continuous
Red Tone
Yellow None
Flashing None
Yellow
Flashing None
Yellow
2
Status Light/Tone
Mode
All On-Line and ready to print
All Battery is low, recharge the printer. At this
point the battery is at approximately 10% of its
capacity and can print less than 1000
additional linear inches.
All Printer error:
Caused by a paper-out condition or a
hardware failure. If paper is out, follow
instructions in section 2.3, otherwise turn
printer off and back on. If condition persists,
contact your service representative.
All The battery pack is too low for proper printer
operation. The unit will remain in this mode
until the battery is recharged or the printer is
powered off.
Tag/tear, Label present. Label is ready to be removed
Peel from the printer mouth.
Batch Printer is in standby mode and waiting for the
front panel button to be pressed.
After Printer is waiting to continue processing. The
Paper-Out label button must be pushed twice to clear
yellow after loading.
Table 1
405 Addendum to 410 Operators Manual
Meaning