Adjust The Oven Thermostat - GE JBS07 Owner's Manual And Installation Instructions

Adjust the oven thermostatmEasy to do yourself!
ge.com
Youmay find that your new oven cooks differently than the one it replaced. Use your new oven for a few weeks to
become more familiar with it. If you still think your new oven is too hot or too cold, you can adjust the thermostat yourself.
Do not use thermometers, such as those found in grocery stores, to check the temperature setting of your oven. These
thermometers may vary 20-40°F.
NOTE: This adjustment will not affect the broiling or the self-cleaning temperatures (on some models). The adjustment
will be retained in memory after a power failure.
Front of OVENTEMPknob
(knobappearance may vary)
Pointer
ToAdjust the Thermostatwith this Typeof Knob
[]
[]
Pull the OVEN TEMP knob off the range
and look at the back side.
To make an a(!justment, loosen
(appro_mately one turn), but do not
COlnpletely relilOve, tile two screws on
file back of tile knob.
To increase tile oven temperature,
mo_e tile pointer to,_ard tile ,_ords
"MAKE HOTTER."
To decrease the oven teinperature,
turn tile pointer toward tile words
"MAKE COOLER."
[]
[]
Each click will change tile o',en
temperature appro_mately 10°K
(Range is plus or mimls 60°F fi'om the
arrow.) We suggest that you make tile
a(!}usm_ent one click fl'om the original
setting and check oven perIbrmance
befiwe making any additional
a(!iUStl//ents.
After the adjustment is made, retighten
scre_vs so tile}' are snug, but be careflll
not to ove_ighten.
Replace tile knob, matching tile fiat
area of tile knob to tile shall and
check perfkmnance.
Back of OVENTEMPknob
(knob appearance may vary)
OVEN
P
o iI
Front of OVENTEMPknob
(knobappearance may vary)
Back of OVENTEMPknob
(knob appearance may vary)
To Adjust the Thermostat with this Type of Knob
[]
[]
Pull the OVEN TEMP knob off the range
and look at the back side.
To make an a(!justment, loosen
(approximately (me turn), but do not
completely remove, tile two screws on
the back of the knob.
XMth tile back of tile knob ti_cing _,ou
hold tile outer edge of tile knob with
one hand and tm'n tile fl'ont of tile
knob with tile other hand.
To increase tile oven temperature,
move tile top screw towar(1 tile fight.
Y)m'll hear a click tor each notch wm
move tile knob.
[]
[]
Each click will change tile oven
temperature approximately 10°E
(Range is plus or mimls 60°F fl'om the
arrow.) We suggest that vou make the
a(!justment one click fl'om the original
setting and check oven pe_ti)mmnce
before making any additional
a(!justments.
After the adjustment is made, refighten
screws so they are snug, but be carefld
not to overtighten.
Replace tile knob, matching tile fiat
area of the knob to the shall and
check perlmmance.
To decrease tile oven temperature,
move tile top screw toward tile leti.
:)iill i i !i i
To Adjust the Thermostat on Other Models
[] Touch tile BAKE and BROIL HI/LO pads [] X_q/en you ha_e made tile a@_stment,
at tile same time ti)r 2 seconds tmtil
touch tile START/ON pad to go back to
tile display sho_vs SE tile time of day display. Use your oven
as vou would nOlillallv.
[] Touch the BAKE pad. A two digit
nulnber sh(m:s in tile
display:
NOTE." T hisadjustment will not affect the broiling
[] Tile oxen temperatm'e can be ac!justed or se/f-c/eanlbg temperatures.It wi//be retalbed
:450_ lb memoryafter a power failure.
up to (+) 35°F hottei or (-) . : l_
coole_: Touch tile + pad to increase tile
temperature in 1 degree increments.
Touch tile -pad to decrease tile
temperatm'e in 1 degree increments.
21
-g.
w
m
w= m=
} ,,
g
m
_#_
q