Turning On And Projecting; No Image Is Projected; Adjusting Position And Focus; Turning The Projector Off - Epson EMP-X3 User Manual

Turning on and Projecting

• When using the "Direct
Power On" feature, the
power turns on when the
power cable is connected.
• When using above an
altitude of about 1500 m,
make sure you set the "High
Altitude Mode" to "On".
User's Guide "Extended
Menu"
Control Panel Remote Control
Power Indicator
Reading the Indicators
Flashing
Lit
● No image is projected ●
■ For notebooks and computers with liquid
Orange Standby
crystal displays
Press to start
Change the computer's
projecting.
output source. Hold
In this mode, you can unplug
down the
the power cable.
press the appropriate
key (the one usually
Green Warming up labelled
changing the setting,
Wait for a short
time (about 30 wait a few seconds for
seconds).
projection to start.
In this mode pressing has Computer's "User's
Guide"
no effect.
* If the image is not
projected, press
Green Projecting
■ For video equipment
Start playback then
press
(Accessory
Power Cable)
* For video equipment,
press "play" to start
playback.
Examples
NEC
Panasonic
key and
SOTEC
HP
TOSHIBA
IBM
/ ). After
SONY
DELL
FUJITSU
Macintosh Set mirror setting
or display
detection.
Depending on
your OS, you can
.
select them by
pressing
.
● Adjusting Position and Focus ●
(Setting up for the first time or after moving)
■ Raising the Projection Position (Adjusting the front foot)
When moving the projector, make sure
the front foot is retracted.
Correcting Keystone Distortion
You can adjust the vertical tilt to a maximum of
about 30°*.
Wide Top Normal
* The greater the angle of tilt, the harder the
image is to focus. Setup the projector at a lower
angle of tilt.
■ Adjusting Focus
After keystone correction and
sharpness adjustments, the image
may be unfocused.
● Turning the Projector off ●
.
Turn off all connected equipment.
Press twice on the remote
control or control panel.
* If you turn the power on straight after turning it off, the time before projection starts becomes longer than usual.
Foot Adjust
Lever
You can adjust the front foot to raise the
projection angle up to a maximum of 10°.
• When the "Auto Keystone" function
is turned "Off" in the configuration
menu, automatic keystone
correction is not performed.
Wide Base
(EMP-82/62 only)
• You can also make keystone
corrections from the configuration
menu.
User's Guide "Settings Menu"
• Hold down
and press
more than one second to reset the
correction value to the default
setting.
• Adjust the horizontal tilt by turning
the left rear foot.
Rear Adjustable
Foot
Extend
■ Adjusting Projection Size
Enlarge
After the confirmation buzzer beeps
twice, unplug the power cable.
Electricity is consumed if only the projector's
power is turned off.
Attach the lens cover.
for
Retract
Reduce
iii