Network Configuration - Epson POWERLITE 450W Quick Setup Manual

Network configuration

If you need to configure the projector for your network, you can use the
projector's menu system.
1
Press the Menu button on the remote control, select the Network
menu, then press Enter.
2
Choose Network Configuration and press Enter.
3
Select the Wired LAN menu and press Enter.
4
Choose IP Settings and press Enter. You see a screen like the following:
5
Do one of the following:
•
If your network assigns addresses automatically, turn on the DHCP
setting.
•
If your network does not assign addresses automatically, turn off
DHCP and enter the projector's IP Address, Subnet Mask, and
Gateway Address, as needed.
To enter numbers, use the
highlight the number you want to input, then press the Enter button.
When you're finished entering an address in the network menu,
highlight Finish, then press the Enter button. Press the Esc button to
reutrn to the previous menu.
6
When you're done making all necessary changes, press the Esc button,
select Complete and press the Enter button to save your settings. Then
press Enter again to confirm.
7
Press the Menu button to exit the menu system.
buttons on the remote control to
Using web remote
You can use a standard web browser to control the projector through the
network. A "virtual remote control" on your computer screen lets you perform
many of the same functions as you can with the physical remote control.
1
Open your web browser and enter the IP address of the projector you
want to monitor in the browser window.
If you're not sure what the address of the projector is, turn the projector
on and select Net. Info.-Wired LAN or Net. Info.-Wireless LAN from
the Network menu to display the IP address of the projector. (Do not
enter the leading zeroes.)
2
Press Enter, or, if you set a web control password in the projector's
Network menu, enter your user name and password, then press Enter.
3
From the Projector Control menu, select Web Remote. Use the on-screen
buttons to operate the projector, as you would using the remote control.
Select video signal
Select computer signal
Turn off picture
and sound
Select equipment connected
to the USB port
Select wired or wireless
network signal
Pause video
Display closed captions