Epson POWERLITE 450W Quick Setup Manual
Garmin projector user manual
Hide thumbs
Also See for POWERLITE 450W:
- User manual (174 pages) ,
- Brochure & specs (4 pages) ,
- Replacement manual (4 pages)
Advertisement
Quick Links
PowerLite
450W/460
®
Quick Setup
Before using the projector, make sure you read the safety instructions in the
User's Guide on your projector CD.
Connect the projector
Before you can connect to the projector, you need to loosen the screws and
remove the cable cover.
Choose from the following connections:
Computer Monitor Port
Connect a computer using the VGA cable that came with the projector.
Connect one end to the projector's Computer1 or Computer2 port, and
the other end to your computer's
laptop, switch it to external display. You can also connect an audio cable or
microphone.
Computer USB Port
Connect a computer using a USB cable.
Connect the square end of the USB cable to the projector's TypeB
(square) USB port. Connect the flat end of the cable to any USB port on your
computer. You can also connect an audio cable or microphone.
Follow the on-screen instructions to install the Epson USB Display software. If
you see warning messages, click OK or Continue. (Software is installed only
the first time you connect the computer.) Press the USB button on the remote
control if necessary.
*411850400*
*411850400*
monitor port. If you are using a
Network (LAN)
Connect the projector to your network using an Ethernet
over the network" for more information.
Microphone
Connect a dynamic or condenser microphone to the Mic port, using a 3.5 mm
mini-jack cable.
Video Player
Connect up to 4 video devices and use the remote control to switch between
them.
S-Video
RCA video cable
cable
(composite video)
(optional)
(optional)
Interactive Whiteboard or Document Camera
Connect an interactive whiteboard or document camera to the projector's
TypeA
(flat) USB port.
For information on playing sound through the projector or connecting an
external monitor, see the User's Guide on your projector CD.
cable. See "Project
®
Component video
Audio cable
to VGA cable
(optional)
(optional)
Advertisement
Related Manuals for Epson POWERLITE 450W
Summary of Contents for Epson POWERLITE 450W
-
Page 1: Quick Setup
Before using the projector, make sure you read the safety instructions in the User’s Guide on your projector CD. Connect the projector Before you can connect to the projector, you need to loosen the screws and remove the cable cover. Choose from the following connections: Computer Monitor Port Connect a computer using the VGA cable that came with the projector. -
Page 2: Using The Remote Control
If you need to focus the image, first slide the switch to open the air filter cover on the side of the projector. Then raise or lower the focus lever to sharpen the image. -
Page 3: Network Configuration
Network configuration If you need to configure the projector for your network, you can use the projector’s menu system. Press the Menu button on the remote control, select the Network menu, then press Enter. Choose Network Configuration and press Enter. -
Page 4: Troubleshooting
Try using the CRT/LCD or key as described above. On most systems, this key lets you toggle between the LCD screen and the projector, or display on both at the same time. Depending on your computer’s video card, you might need to use the Display utility in the Control Panel to make sure both the LCD screen and the external monitor port are enabled.