Electrical Connections - GE JDP47 Installation Instructions Manual

Installation Instructions
Electrical Connections
[_ emove house fuse or open circuit
breaker.
Loosen screws for the junction box
cover and rotate out of place or remove
the cover.
Examine the junction box location to
determine the best routing of the
conduit, and select the best available
7/8" diameter knockout. Avoid using
holes in the top of the junction box to
prevent the conduit from interfering
with the back of the range.
Break open the selected knockout by
placing a bladed screwdriver on the
scored opening in the junction box and
striking the screwdriver with a hammer.
(Pliers may be required to complete the
removal of the knockout.)
7/8" Knockout
Cover Rotated
From Box Opening
Position the range in front of the
opening, but slightly to the side,
in a manner so that a person can enter
the opening to wire the range to the
house wiring in the junction box.
Feed wires and conduit through the
open hole and snap the conduit fitting
into the hole. Route the conduit in a
manner that will not interfere with the
rear wire cover. The conduit must be
routed below the wire cover.
WARNING:
Improper
connection of aluminum house
wiring to copper leads can
result in an electrical hazard or fire.
Use only connectors designed for
joining copper to aluminum and follow
the manufacturer's recommended
procedure closely.
GENERAL NOTE FOR ALL WIRE NUT
APPLICATIONS: THE PROPER SIZE WIRE
NUT SHALL BE PLACED OVER THE
STRIPPED LEADS AND THE WIRE NUT
TWISTED UNTIL THE WIRE NUT CAN
NOT BE PULLED FROM THE LEADS.
NO CONDUCTOR SHALL BE EXPOSED
IN THE CONNECTION. THE EXCEPTION
TO THE CONDUCTOR BEING EXPOSED
IS THE BARE COPPER GROUND
CONNECTION.
BREAKER OR FUSE SIZE
240V I 40 Amps +
208V I 40 Amps +
+ NOTE: Check Local Codes for
required breaker size.
6 (Continued on following page)