Table of Contents
Advertisement
Calibrating the GPSMAP 7000 Series Touchscreen
The GPSMAP 7000 series chartplotter touchscreen does not normally require calibration. However,
if the buttons do not seem to be responding properly, use the following process to calibrate the
screen.
1. While the chartplotter is turned off, press the
The Warning screen appears.
2. Touch anywhere on the black portion of the screen for approximately 15 seconds until the
calibration screen appears.
3. Follow the instructions on the screen until "Calibration is complete" appears.
4. Touch oK.
Screenshots
Note: To capture screenshots using a GPSMAP 7012, 7212, 7015 or 7515, you must use the
Garmin RF Wireless Remote Control.
You can capture as a bitmap (.BMP) file a screenshot of any screen shown on your chartplotter, and
transfer the file to your computer.
Capturing Screenshots
1. Insert a memory card into the SD card slot on the front of the chartplotter.
Configure
2. Select
>
3. Go to a screen you want to capture.
4. Take a screenshot:
•
For the GPSMAP 6000 series, press the
•
For the GPSMAP 7000 series, press the
Control for at least six seconds.
The Screenshot Taken window appears.
5. Select oK.
Copying Screenshots to a Computer
1. Remove the memory card from the chartplotter and insert it into an SD card reader that is
attached to a computer.
2. From Windows Explorer, open the Garmin\scrn folder on the memory card.
3. Copy a .BMP file from the card and paste it to any location on the computer.
Viewing GPS Satellite Locations
You can view the relative position of GPS satellites in the sky.
From the Home screen, select
System Information
Viewing System Information
See "Viewing System Information"
GPSMAP
6000/7000 Series Owner's Manual
®
System
Beeper/Display
>
Configure
>
(page
Power
key.
Screenshot Capture
>
HoMe
key for at least six seconds.
HoMe
button on the Garmin RF Wireless Remote
System
> GPS.
4).
Appendix
> on.
Hide quick links:
Advertisement
Table of Contents
