Vehicle Installation - Garmin Trail Guide Owner's Manual

G s > V
ettInG tarted ehIcle

Vehicle Installation

E
You can install and store the Trail Guide in the dealer-installed
N
vehicle mount. The Trail Guide runs off power from your vehicle
when the ignition is turned on. Be sure the vehicle ignition is
turned off before you install or remove the unit from
the mount.
To install the Trail Guide in the mount:
1. Flip up the GPS antenna on the back of the Trail Guide.
2. Position the unit directly above the vehicle mount and line
up the sides of the unit with the sides of the mount.
3. Slide the unit straight down until it clicks into place.
To remove and store the Trail Guide:
1. Pull the Trail Guide straight up and out of the vehicle mount.
2. Store the Trail Guide in the slot behind the vehicle mount.
Pull down the mount door to hide the unit from sight.

I
nstallatIon
Your vehicle mount looks like one of the two shown below.
Trail Guide Owner's Manual
™