Step 4: Configuring The Printer - Datamax H class Installation Instructions Manual

Step 4: Configuring the Printer

While the Present Sensor is a plug and play device, this step may be necessary if the printer's default
configuration has been changed. Follow the steps below to configure the printer:
Note: In the following procedure, consult the Operator's Manual for detailed front panel instructions.
A) Press the MENU Button on the printer's front panel.
B) Using the DOWN Button, scroll to PRINTER OPTIONS then press the RIGHT Button.
C) Using the DOWN Button, scroll to PRESENT SENSOR then press the ENTER Key.
D) Using the DOWN Button, scroll to MODE then press the ENTER Key.
E) Using the DOWN Button, scroll to AUTO then press the ENTER Key.
F) Press the EXIT Key then, at the SAVE CHANGES? prompt, select YES to complete the installation.
G) Turn the Power Switch 'Off' and 'On' to reset the printer and complete the configuration.
4