Kenmore HE4 110.8508 Series Use And Care Manual page 9

Power Supply Cord Direct Wire
Fire Hazard
Use a new UL listed 30 amp power supply cord,
Use a UL listed strain reliefo
Disconnect power before making electrical connections,
Connect neutral wire (white or center wire) to center
terminal (silver)°
Ground wire (green or bare wire) must be connected to
green ground connecter°
Connect remaining 2 supply wires to remaining
2 terminals (gold).
Securely tighten all electrical connections,
Failure to do so can result in death, fire, or
electrical shock.
1. Disconnect power,
2. Remove the hold-down screw and terminal block cover.
J
D
/
A. Neutral grounding wire (green with yellow stripes)
B. External ground conductor screw
C. Center, silver-colored terminal block screw
D. Terminal block cover and hold-down screw
Fire Hazard
Use 10 gauge solid copper wire,
Use a UL listed strain relief,
Disconnect power before making electrical connections,
Connect neutrat wire (white or center wire) to center
terminal (silver).
Ground wire (green or bare wire) must be connected to
green ground connector,
Connect remaining 2 supply wires to remaining
2 terminals (gold),
Securety tighten all electrical connections,
Failure to de so can result in death, fire, or
electrical shock,
3. Add strain relief.
Style 1: Power supply cord strain relief
• Remove the screws from a 3/4"(1.9 cm) UL listed strain
relief (UL marking on strain relief). Put the tabs of the two
clamp sections into the hole below the terminal block
opening so that one tab is pointing up and the other is
pointing down, and hold in place. Assemble and tighten
strain relief screws just enough to hold the two clamp
sections together.
......... B
A. Strain relief tab
B. Clamp section
Put power supply cord through the strain relief. Be sure
that the black part of the power supply cord is inside the
strain relief. The strain relief should have a tight fit with the
dryer cabinet and be in a horizontal position.