Table of Contents
Advertisement
Using Your Humidifier
Step 1
Be sure humidifier
is full of water
and
plugged in.
Step 2
Set Speed Control _
to low speed ,,o,
Step 3
Set Humidity Control
@
to a medium
position.
NOTE:
Humidifier
should
operate
with
humidity
control
on the
recommended
medium setting, tf it does not, the humidity
is at a relatively high level. To test the unit
under this condition, turn Humidity Control
all the way clockwise and unit should begin
to operate. After the unit has been tested,
set Humidity Control to medium or desired
level.
Allow 24 hours for humidifier to adjust.
If humidity level in home is sufficient, the
humidifier will only operate with Humidity
Control turned al! the way clockwise.
IMPORTANT: Water damage may result
if condensation
starts to form on win-
dows or walls. Humidity Control setting
should be lowered until condensation
no longer forms.
Step 4
If humidifier stops running and the unit is
not empty the humidity level is at the nor-
mal requirements
for that setting or it is
adjusting to the home conditions. The table
below shows recommended
indoor humid-
ity levels. The figure below shows approxi-
mate relative humidity percentages
which
correspond
to the various settings of the
Humidity Control.
Recommended
When Outdoor
Indoor Relative
Temperature
is:
Humidity is:
-10°F
20%
0°F
25%
10°F
30%
20°F & above
35%
Relative Humidity
Operating
Tips for Best Performance
1. Position the humidifier at least 2 inches
from any wall and away from any heat
registers.
2. Do not restrict airflow from entering or
exiting the humidifier.
3. Use Sears recommended
bacteriostat
42-14900 to retard bacteria growth that
may cause odors and may be harmful
to your health.
4. Perform regular cleaning as instructed
in "Cleaning Your Humidifier" section of
this manual.
5. Replace the evaporative
wicking filters
at least once per humidification season
or more depending on water conditions
in your area.
Hide quick links:
Advertisement
Table of Contents
