Getting Ready To Sew; Connecting Machine To Power Supply; Before Using Your Sewing Machine; Foryour Safety - Singer 384.13016300 Owner's Manual

GETTING READY TO SEW
Connecting Mach ine to Power Supply
(_ Power supply plug (_ Power switch
(_ Outlet _) Machine socket
_) Machine plug _) Light bulb
Before connecting the power cord, make sure the voltage
and frequency shown on the machine conform to your
electrical power.
1. Turn off the power switch _.
2. Insert the machine plug @ into the machine socket _).
3. Insert the power supply plug (_ into the outlet _.
4. Turn the power switch _)to turn on the power and sewing
light _).
Before
Using Your Sewing
Mach ine
Before using your sewing machine for the first time, place a
waste fabric under the presser foot and run the machine
with thread for a few minutes. Wipe away any oil which may
appear.
ForYour
Safety
* While in operation, always keep your eyes on the sewing
area. Do not touch any moving parts such as the thread
take-up lever, handwheel or needle.
* Always turn off the power switch and unplug from the
power supply:
• When leaving the machine unattended.
• When attaching or removing any parts.
• When cleaning the machine.
* Do not place anything on the foot control, when not
sewing.
Polariz ed
Plug
This appliance has a polarized plug (one blade wider than
the other). To reduce the risk of electric shock, this plug is
intended to fit in a polarized outlet only one way. If the plug
does not fit in the outlet, reverse the plug. If it still does not
fit, contact a qualified electrician to install the proper outlet.
Do not modify the plug in any way.
Foot Controller Model YC-482J-1 or TJC-150 is used with
Sewing Machine Model 384.13016XXX (XXX represents
numbers OOO through 999).
\
\
Controlling Sewing Speed
Sewing speed is varied by the foot control.
The harder you press on the foot control, the faster the
machine runs.
6