Read and follow all Safety Rules After having read this manual, and Operating Instructions if you have any questions before first use of this Product. or are missing parts on your Kenmore humidifier, call: 1-888-838-0807 Sears, Roebuck and Co., Hoffman Estates, IL 60179 U.S.A.
FULL ONE-YEAR WARRANTY For one year from the date of purchase, if this Kenmore Humidifier fails due to defects in material or workmanship, return it to your nearest Sears store and it will be replaced free of charge. This warranty DOES NOT cover the absorption sleeve, which is an expendable part.
GENERAL SAFETY INSTRUCTIONS • As with all electrical appliances, be sure to follow basic safety procedures to minimize risk of injury. • To avoid electrical shock or fire, be sure to plug into a 120v AC outlet only. Make sure the plug is fully inserted. •...
GETTING TO KNOW YOUR HUMIDIFIER Model No. 997.151230 (2.0 Gallon) 1. Tank 7. Medicine 2. Cap 8. Tank Carry Handle (top) 3. Base 9. Tank Carry Handle (bottom) 4. Mist Chamber 10. Safety Switch 5. Power Control Knob 11. Locking Device 6.
INTRODUCTION Congratulations on your purchase of your new Kenmore Warm Mist Humidifier with exclusive Warm Wicking Vapor System'. You have purchased the newest and most advanced technology available in warm mist humidifiers. This patented technology creates an extremely quiet, low-maintenance humidifier.
HOW YOUR HUMIDIFIER WORKS Water flows from the tank(s) into the humidifier base. The water is then absorbed up the absorption sleeve where it is heated, purified and converted into warm mist. The warm mist then rises up through the mist chamber, dispensing comfortable, soothing, invisible moisture into the air.
SET-UP Remove the tank(s), turn the tank(s) upside down and remove the fill cap by turning counter-clockwise. Fill the tank(s) with cool water, for best results use distilled or filtered water. Do not use hot water or any chemical additives. Replace the fill cap by turning clockwise, be sure not to overtighten.
WARNING: Do not attempt to plug the humidifier in with wet hands, as an electrical shock may occur. Turn the Humidistat Control Knob to the MAX position (far right). Turn the Power Control Knob to the desired position: HIGH for fast humidification or LOW for more gradual humidification.
Be sure to use only Kenmore absorption sleeves with your humidifier. Using anything other than Kenmore absorption sleeves may cause damage to the humidifier, create a safety hazard, and void the warranty. CAUTION: Be sure the humidifier has cooled sufficiently before handling the humidifier.
Attach a new or cleaned absorption sleeve to the heating element. Pull sleeve tightly around the heating element and secure it with the attached Velcro ® fastener. See illustrations below. NOTE: It is important to be sure the sleeve is very tight around the heating element for best performance.
Periodically wipe down the outside of the humidifier with a damp, soft cloth. Do not use harsh, abrasive cleaners on this humidifier. Never submerse the mist chamber in liquid or pour liquid in or on the mist chamber. Doing so may damage the unit and may cause injuries.
When ordering replacement parts, always give the following information: 1. Part Number (See Replacement Parts List) 2. Part Description (See Replacement Parts List) 3. Kenmore Humidifier Model Number (997.151230) 4. Name of item (Kenmore 2.0 Gallon Warm Mist Humidifier) Customer Service at 1-888-838-0807 p_e11...
1. Part Number (See Replacement Parts List) 2. Part Description (See Replacement Parts List) 3. Kenmore Humidifier Model Number (997.151250) 4. Name of item (Kenmore 3.5 Gallon Warm Mist Humidifier) Customer Service at 1-888-838-0807 page 12...
HELP PAGE Power light _ is not illuminated. • Be sure Power Control Knob is in the HIGH or LOW position. • Be sure humidifier is plugged into the outlet. • Check outlet or circuit breaker. Humidity light 6 is illuminated. •...
Sears, Roebuck and Co., Hoffman Estates, IL 60179 U.S.A.