Kenmore 2.0 & 3.5 gallon warm mist humidifier 997.151230 Owner's Manual page 9

and the humidifier stops producing moisture. When this occurs,
the REFILL light _ will illuminate. The humidifier will not
operate without the tank properly seated in the base. Be sure,
when putting the tank back in the base, that it is set properly
and the tank is putting pressure on the SAFETY SWITCH to
engage power and start the humidifier.
NOTE: Depending on how level and flat the surface is where
you placed your humidifier, models with two tanks may empty
into the base together or separately.
REPLACING THE ABSORPTION SLEEVE
It is recommended that you remove and inspect your
absorption sleeve every time you refill your tank(s). Clean
or replace your sleeve if you notice any mineral buildup or
discoloration on the outside or inside of your absorption
sleeve. Failure to properly maintain your absorption sleeve
can result in poor performance and possible malfunction
of your humidifier. For best results, use distilled or filtered
water.
The absorption sleeve is a vital part of your humidifier. Do not
attempt to use your humidifier without this sleeve. Do not alter
or attempt to repair any absorption sleeve. Be sure to use
only Kenmore absorption sleeves with your humidifier. Using
anything other than Kenmore absorption sleeves may cause
damage to the humidifier, create a safety hazard, and void
the warranty.
CAUTION: Be sure the humidifier has cooled sufficiently
before handling the humidifier.
Remove the tank(s) from the base. Rotate the mist chamber
locking device to unlock the mist chamber. Lift the mist
chamber off the base. Remove the absorption sleeve from the
heating element, found on the underside of the mist chamber.
With a soft cloth or soft toothbrush, wipe away any buildup
from the heating element.
IMPORTANT!
It is recommended that you remove and inspect your
absorption sleeve every time you refill your tank(s). Clean or replace your
sleeve if you notice any mineral buildup or discoloration on the outside or
inside of your absorption sleeve. Failure to properly maintain your
absorption sleeve can result in poor performance and possible malfunction
of your humidifier. For best results use distilled or filtered water.
page 8