Advertisement
Questions?
Use ThSsP blem SoUver
PROBLEM
OVEN WILL NOT
WORK
OVEN LIGHT
DOES NOT WORK
FOOD DOES NOT
BROIL PROPERLY
FOOD DOES NOT
ROAST OR BAKE
PROPERLY
SURFACE
UNITS
NOT FUNCTIONING
PROPERL?(
OVEN DOOR
WON'T
LATCH
POSSIBLE
CAusEAND
REMEDY
o Difficulty
may be in the main distribution
panel of your house by a blown oven
circuit fuse, a tripped
oven circuit breaker, the main fuse or the main circuit
breaker, depending
on nature of the power supply. If a circuit breaker is involved,
reset it, If the control box uses fuses, the oven fuse (a cartridge-type)
should
be
changed
BUT ONLY BY SOMEONE
FAMILIAR
WITH ELECTRICAL
CIRCUITS.
If after doing one of these procedures,
the fuse blows or circuit breaker trips
again, call for service.
NOTE: Apartment
tenants or condominium
owners should request their building
management
to perform this check before calling for service.
o Oven controls
not properly set,
o Door left in locked position
after cleaning.
o Light bulb is loose.
o Bulb is defective.
Replace.
o OVEN SELECTOR
knob not set at BROIL..
o OVEN CONTROL
knob not set at BROIL.
o Door not left ajar as recommended.
o Improper
shelf position
being use&
Check Broiling Guide..
o Necessary
preheating
was not done.
o Food is being cooked on hot pan°
_, Utensils are not suited for broiling.
o Aluminum
foil used on the broil pan rack has not been fitted properly
and slit
as recommended.
,, OVEN SELECTOR
knob not set on BAKE.
o OVEN CONTROL
knob not set correctly.
= Shelf position
is incorrecL
Check Roasting
or Baking Guides.
o Oven shelf is not level.
o Incorrect cookware
or cookware
of improper
size is being used°
o A foil tent was not used when needed to slow down browning
during roasting.
a Surface units are not plugged
in solidly.
a Drip pans are not set securely
in the range top.
,, Surface unit controls
are not properly
set.
OVEN WILL NOT
_,Automatic
timer dials not set or not set properly. Clock must be set to time of day
SELF-CLEAN
and the STOP dial must be set and advanced
beyond the time noted on oven clock.
,, The STOP dial was not advanced
for long enough.
o Both OVEN SELECTOR
and OVEN CONTROL
knobs must be set at CLEAN
setting.
,_A thick pile of spi!lover when cleaned
leaves a heavy layer of ash in spots
which could have insulated the area from further heat.
,, Latch not moved to the right.
o "[ijrn OVEN SELECTOR
knob to CLEAN.
Glowing
Locked Light after knob is
turned indicates
oven is too hot from previous use and door won't latch° To cool
oven, open door wide, then Latch can be moved.
,, OVEN SELECTOR
knob must be at CLEAN or OFF before Latch can be moved..
29
Advertisement
