Step 1: Set The Powerline Network Back To Homeplugav Default; Step 2: Add Logitech Alert Network Adapter (Na750) - Logitech HD Powerline 200a Manual

Powerline Network Utility NA200

STEP 1: Set the Powerline network back to HomePlugAV default

1. Open the Powerline Utility Tool.
2. Click on the Privacy tab. The Privacy tab screen displays.
3. In the Powerline Network Password field, click on the button "Use Default (Public Network)".
4. If each device listed on the main screen has the PWD set for it, then click the button "Set ALL
Devices." This will set all the devices back to the default powerline network password. (If the
PWD is not set for each device on the main screen, refer to the instructions in CASE 1, steps 6 –
8, but using the default network password instead of a custom network password.)

STEP 2: Add Logitech Alert network adapter (NA750)

1. Unplug the HD 200a network adapter that was connected to the Ethernet port of your router or
the Ethernet port of the PC running the Powerline Utility.
2. Plug in the Logitech Alert network adapter (NA750) to the outlet and device that were
previously connected to the HD 200a. You should not plug in another powerline network
adapter to the same PC or router (only one is needed).
3. You can plug in the HD 200a or other powerline network adapters into other outlets and devices
that need it.