OPERATION MANUAL English SPLIT SYSTEM Air Conditioner Chinese MODELS (Duct Connection type) Arabic FDY06KAY1 FDY08KATAL FDY08KAYAL FDY08KAY1 FDY10KATAL FDY10KAYAL FDY10KAY1 FDY15KATAL FDY15KAYAL FDY15KAY1 FDY20KATAL FDY20KAYAL FDY20KAY1...
Page 2
Thank you for purchasing this Daikin air condi- tioner. Carefully read this operation manual before using the air conditioner. It will tell you how to use the unit properly and help you if any trouble occurs. After reading the manual, file it...
Otherwise, your physical condition may be dete- NOTE riorated and/or your health may be ruined. • Contact your Daikin dealer if changing the combi- When the air conditioner is in abnormal condi- nation or setting of group control and two remote...
Do not insert your finger, a stick, etc., into the An electric shock may result. air inlet, outlet, and fan blades. Do not install the air conditioner at any place where flammable gas may leak out. A fan in high-speed running may result in injury. If the gas leaks out and stays around the air con- For refrigerant leakage, consult your dealer.
4. INSTALLATION SITE 5. NAME AND FUNCTION OF EACH SWITCH AND DISPLAY ON THE Regarding places for installation • Is the air conditioner installed at a well-ventilated REMOTE CONTROLLER place where there are no obstacles around? Refer to figure 1 on page [1] •...
INSPECTION/TEST OPERATION BUTTON ON/OFF This button is used only by qualified service persons for maintenance purposes. Press ON/OFF button PROGRAMMING TIME BUTTON OPERATION lamp lights up and the system starts OPERATION. Use this button for programming “START and/ or STOP” time. [EXPLANATION OF HEATING OPERATION] TEMPERATURE SETTING BUTTON DEFROST OPERATION...
The display vanishes. Once every 2 weeks is recommended. NOTE • The air filter and the suction grille are commer- cially available. • Ask your DAIKIN dealer how to clean them. English...
It is necessary to clean the inside of the indoor • When the main power switch is turned on, some unit. Ask your Daikin dealer for details on cleaning the watts of electricity is being used even if the sys- unit.
MALFUNCTION CODE IV.DUST FROM THE UNITS Measure: Notify your Daikin dealer and inform • Dust may blow out from the unit after starting him/her of the display. operation from long resting time. II. If the system does not properly operate except Dust absorbed by the unit blows out.