Non-Physical Features - ZyXEL Communications P-334U User Manual

P-334U/P-335U User's Guide
Auto-crossover 10/100 Mbps Ethernet Interface(s)
These interfaces automatically adjust to either a crossover or straight-through Ethernet cable.
4-Port Switch
A combination of switch and router makes your ZyXEL Device a cost-effective and viable
network solution. You can add up to four computers to the ZyXEL Device without the cost of
a hub. Add more than four computers to your LAN by using a hub.
Reset Button
The reset button is built into the rear panel. Use this button to restore the factory default
password to 1234; IP address to 192.168.1.1, subnet mask to 255.255.255.0 and DHCP server
enabled with a pool of 32 IP addresses starting at 192.168.1.33.
Dual Band Switch
You can use the AG switch on the rear panel to allow either IEEE 802.11a or IEEE 802.11b/g
compliant wireless devices to communicate with the ZyXEL Device wirelessly.
USB Port (P-335U only)
The P-335U uses a USB 1.1 port to connect to a printer with a USB interface. Printers that use
USB 1.0 are also compatible. Computers on the LAN use the printer by sending print requests
to the print server in the P-335U.
OTIST Button
Use this button to activate OTIST (One-Touch Intelligent Security Technology). OTIST
allows your ZyXEL Device to assign wireless clients the ZyXEL Device's SSID and static
WEP or WPA-PSK encryption settings. The wireless client must also support OTIST and have
OTIST enabled.

1.2.2 Non-Physical Features

Print Server (P-335U only)
The P-335U has a built-in print server that allows computers on the LAN to share a USB
printer. This eliminates the need to assign a dedicated computer as a print server or have a
standalone print server device.
Bandwidth Management
ZyXEL's Bandwidth Management allows you to specify bandwidth classes based on an
application and/or subnet. You can allocate specific amounts of bandwidth capacity
(bandwidth budgets) to different bandwidth classes.
30 Chapter 1 Getting to Know Your ZyXEL Device