Using Wps - ZyXEL Communications P-660N-T1A User Manual

4.2.2 Using WPS

This section shows you how to set up a wireless network using WPS. It uses the
ZyXEL Device as the AP and ZyXEL NWD210N as the wireless client which
connects to the notebook.
Note: The wireless client must be a WPS-aware device (for example, a WPS USB
adapter or PCMCIA card).
There are two WPS methods to set up the wireless client settings:
• Push Button Configuration (PBC) - simply press a button. This is the easier
of the two methods.
• PIN Configuration - configure a Personal Identification Number (PIN) on the
ZyXEL Device. A wireless client must also use the same PIN in order to
download the wireless network settings from the ZyXEL Device.
Push Button Configuration (PBC)
Make sure that your ZyXEL Device is turned on and your notebook is within the
1
cover range of the wireless signal.
Make sure that you have installed the wireless client driver and utility in your
2
notebook.
In the wireless client utility, go to the WPS setting page. Enable WPS and press
3
the WPS button (Start or WPS button).
Push and hold the WPS button located on the ZyXEL Device's rear panel for more
4
than 5 seconds. Alternatively, you may log into ZyXEL Device's web configurator
and click the Push Button in the Network > Wireless LAN > WPS Station
screen.
Note: Your ZyXEL Device has a WPS button located on its rear panel as well as a
WPS button in its configuration utility. Both buttons have exactly the same
function: you can use one or the other.
P-660N-T1A User's Guide
Chapter 4 Tutorials
41