ZyXEL Communications P-660N-T1A User Manual page 125

Take the following steps to set up a WPS connection between an access point or
wireless router (referred to here as the AP) and a client device using the PIN
method.
Ensure WPS is enabled on both devices.
1
Access the WPS section of the AP's configuration interface. See the device's User's
2
Guide for how to do this.
Look for the client's WPS PIN; it will be displayed either on the device, or in the
3
WPS section of the client's configuration interface (see the device's User's Guide
for how to find the WPS PIN - for the ZyXEL Device, see
Enter the client's PIN in the AP's configuration interface.
4
If the client device's configuration interface has an area for entering another
5
device's PIN, you can either enter the client's PIN in the AP, or enter the AP's PIN
in the client - it does not matter which.
Start WPS on both devices within two minutes.
6
Use the configuration utility to activate WPS, not the push-button on the device
7
itself.
On a computer connected to the wireless client, try to connect to the Internet. If
8
you can connect, WPS was successful.
If you cannot connect, check the list of associated wireless clients in the AP's
configuration utility. If you see the wireless client in the list, WPS was successful.
P-660N-T1A User's Guide
Chapter 8 Wireless LAN
Section 8.4 on page 111).
125