Master/Slave Fixture Linking - Chauvet Sparklite LED User Manual

Setup
The Master/Slave mode allows one SparkliteLED™ controller (the master) running
Master/Slave
a preconfigured program to control several SparkliteLED™ controllers (the slaves)
Fixture Linking
without requiring a DMX controller. In this mode, the drapes connected to the
master and slave SparkliteLED™ controllers will operate in unison.
The SparkliteLED™ uses the serial link (Link Output to DMX Input) for its
Master/Slave mode as well.
1. Link the fixtures as indicated in steps 3 to 5 of the previous section.
2. Make sure that there is no DMX controller connected to the daisy chain.
3. Follow the steps indicated in the "Operating Instructions" chapter of this manual
to configure the master and the slave fixtures.
Slave SparkliteLED™
Master SparkliteLED™
Master/Slave Linking
DMX
Link Link
DMX
Diagram
Input
Output Output
Next Slave Input
SparkliteLED™
Drape Drape Drape Drape
Drape Drape Drape Drape
1 2 3 4
1 2 3 4
April 8, 2010 11 SparkliteLED™ User Manual - Rev. 02c