Advertisement
Electrode
Check
- Requires
an Assistant
Before placing the cooking components into your
grill, ensure that the Spark Electrode Tip is properly
positioned within each Gas Collector Box (a 4"
wide stainless mechanism found at the front be-
tween each set of Burners.) The easiest way to
ensure this is to perform this Electrode Check:
1.
Be sure all Control Knobs are set to "OFF"
and open the Grill Lid.
2.
Have an assistant stand behind to the right of
the grill and look down at each Gas Collector
Box. NEVER put your face inside Grill Head.
.
Push and turn each Control Knob to High.
You should hear a "spark" sound and your
assistant
should see a small blue spark within
each Gas Collector
Box. If a spark is present,
the Electrode Tips are properly positioned.
4.
If no spark is seen, the Spark Gap shown in
Figure 10 needs to be adjusted as follows:
5.
Using an adjustable wrench, loosen the Inside Nut
just until the Gas Collector Box can be maneuvered
and turned upward.
The gap between the Spark Electrode Tip and
Spark receiver should be approximately
3/16".
If the gap is wider than 3/16" use a pair of long nose
pliers and gently squeeze the Gas Collector Box
until the gap is correct.
Return the Gas Collector Box to its original horizon-
tal position, secure the Inside Nut and try the
Electrode Check again.
If no "spark" sound is heard, call our
Grill Information
Center
at 1-888-317-7642.
Figure
10 - Side View
GAS COLLECTOR
BOX
INSIDE NUT
/
SPARKGAP
SPARKELECTRODE
TIP
\
SPARK
RECEWER
12
Advertisement
