Cleaning The Shuttle Race; Cleaning The Shuttle Area; Replacing Shuttle Assembly - Kenmore 385.15518000 Owner's Manual

Cleaning the Shuttle Race
This area must be kept free of dust, lint and
occasional tangled thread Clean the shuttle race area
about every three months.,
, Cleaning the shuttle area
0 Bobbin case
(_) Levers
(_ Shuttle race cover
@ Shuttle
(_) Shuttle race
(_) Center pin on the shuttle
1, Raise the needle bar to its highest point and remove the
bobbin case (_)r
2. Push shuttle race levers (_) aside, Lift shuttle race cover
(_ and take shuttle @out.
3 Clean the shuttle race 0 with a lint brush_
4 Put a drop of oil on the center pin of the shuttle (_) and
shuttle race (_).. Do not over oil,
• Replacing shuttle assembly
(_) Levers
(_) Shuttle race cover
@ Shuttle
(_ Shuttle race
(_) Center pin on the shuttle
(_ Shuttle driver
(_ Pointed hook
(_) (Oil here)
1, Turn handwheel so that shuttle driver Q is forming half
moon on the left side of the machine.
2, Hold shuttle@ by center pin (_) and position shuttle so
as to form a half moon on the right side. The pointed
hook will be on the bottom,,
3. Place shuttle race cover _) into place over shuttle _)
assembly.
4_ Snap the levers @') back into the original position,
f
J
.%
7O