Cleaning The Shuttle Race; Cleaning The Shuttle Area; Replacing Shuttle Assembly - Kenmore 385.15008100 Owner's Manual

Cleaning the Shuttle Race F
This area must be kept free of dust, lint and tangled thread.
Clean the shuttle race area every three months.
• Cleaning the shuttle area
(_ Bobbin case
_) Levers
_) Shuttle race cover
(_ Shuttle
@ Shuttle race
_) Center pin on the shuttle
1. Raise the needle bar to its highest point, then and
remove the bobbin case (_1_.
2. Push the shuttle race levers (_ aside. Lift out the shuttle
race cover (_ and take the shuttle (_ out.
3. Clean the shuttle race @ with a lint brush.
4. Put a drop of oil on the center pin of the shuttle (_ and
the shuttle race @. Do not over oil.
• Replacing shuttle assembly
(_ Levers
_) Shuttle race cover
(_ Shuttle
@ Shuttle race
_) Center pin on the shuttle
(_ Shuttle driver
(_ Pointed hook
(_ (Oil here)
1. Turn the handwheel so that the shuttle driver(_ forms a
half moon on the left side of the machine.
2. Hold the shuttle _ by its center pinG, and position the
shuttle so that it forms a half moon on the right side. The
pointed hook wilt be on the bottom.
3. Put the shuttle race cover (%} back into place over the
shuttle _ assembly.
4. Snap the levers _ back into the original position.
6O