Advertisement
/ XWARNING
A strong gas smell, or the hissing sound of
gas indicates a serious problem with your
gas grill or the LP gas tank. Failure to
immediately
follow the steps listed below
could result in a fire or explosion
that could
cause serious bodily injury, death, or
property damage.
• Shut off gas supply to the gas grill.
• Turn the Control Knobs to OFF position.
• Put out any flame with a fire extinguisher.
• Open Grill Lid.
• Get away from the LP gas tank.
• Do not try to fix the problem
yourself.
• If odor continues
or you have a fire you
cannot extinguish,
call your fire department.
Do not calt near the LP gas tank because
your telephone
is an electrical
device and
could create a spark resulting
in fire and/or
explosion.
NOTE: The normal flow of gas through
the
regulator and hose assembly
can create a
humming noise. A low volume of noise is
perfectly normal and will not interfere with
operation
of the grill. If humming
noise is
loud and excessive
you may need to purge
air from the gas line or reset the regulator
excess gas flow device. This purging proce-
dure should be done every time a new LP
gas tank is connected
to your grill. For help
with this procedure
refer to page 15, step 4,
or catl the Customer
Service Helpline for
assistance.
Basic Lighting Procedures
1.
Familiarize yourself with the safety guidelines at
the front of this manual. Do not smoke while
lighting grill or checking gas supply connections.
2.
Be sure the LP gas tank is filled.
3.
Check that the end of each Burner Tube is
properly located over each Valve Orifice.
4.
Make sure alt gas connections are securely
tightened.
5. Open the Grill Lid or Side Burner Lid, depending
on the burner you are lighting.
Z WARNING
Failure to open Grill Lid during the
lighting
procedures
could result in a fire
or explosion
that could cause serious
bodily injury, death, or property
damage.
,
Set Control Knobs to OFF and open the LP gas
tank valve slowly until 1/4 to 1/2 open.
Open LP
gas tank
OFF
J
_J
7. Push and turn the LEFT Control Knob to HIGH.
Checking
For LP Gas Leaks
Never test for leaks with a flame. Prior to first
use, at the beginning of each season, or every
time your LP gas tank is changed, you must
check for gas leaks. Follow these four steps:
1. Make a soap solution by mixing one part
liquid detergent and one part water.
2. Turn the grill Control Knobs to the full OFF
position, then turn the gas ON at source.
3. Apply the soap solution to all gas connec-
tions. If bubbles appear in the soap solution
the connections
are not properly sealed.
Check each fitting and tighten or repair as
necessary.
4. If you have a gas leak that you cannot
repair, turn off the gas at the source,
discon-
nect fuel line from your grill and call
1-800-4-MY-HOME ® or your gas supplier for
repair assistance.
HIGH
OFF
8.
Immediately
press the Electric
ignitor for 3-4
seconds to light the Burner.
PRESS
14
9.
If the burner does not light, turn the Control Knob
to OFF, wait 5 minutes for gas to clear, then retry.
10. Once the left grill burner is ignited, the adjacent
burner can be lit by simply turning its Control Knob
toHIGH.
11. Adjust Control Knobs to your desired cooking
temperature.
Advertisement
