Advertisement
Installing Cooking Components
Important:
Before cooking on your grill the first
time, wash the Cooking Grids and Cooking Racks
with warm, soapy water. Rinse and dry thoroughly.
Season with cooking oil regularly. After cooking is
completed, turn gdll to HIGH setting for about five
minutes to burn off excess grease or food residue.
1. Place the 2 Flame Tamers on the lower ledge
above Burners. See Fig. 10.
2.
Evenly space the Cooking Grids on the ledge
above the Flame Tamers.
Figure 10
THIRD
COOKING
RACK
SECONDARY
RACK
COOKING
RACK
3. Place the Secondary
Cooking Rack into the
slots on the upper left and upper right of Grill
Bowl Side Panels. See Fig. 10.
4.
Place Third Cooking Rack on top of the
Secondary
Cooking
Rack. See Fig. 10.
Connecting
A Liquid Propane Gas (LP gas)
Tank To Your Grill
1.
Hang your filled gas tank on the top Tank
Hook. The ring foot of the gas tank will rest
on the Tank Holder. See Fig. 11. Make sure
the LP gas tank valve is in the full OFF
position.
(Turn clockwise
to close.)
2. Check the tank valve to insure it has proper
external mating threads to fit the hose &
regulator
assembly provided.
(Type 1 connec-
tion per ANSI Z21.58a-1998)
.
4.
Make sure all Burner Valves are in the OFF
position.
Inspect the valve connection
port and regulator
assembly.
Look for damage or debris. Remove
any debds. Inspect hose for damage.
Never
use damaged or plugged equipment.
5. When connecting
the hose and regulator
assembly to the tank valve, hand tighten nut
clockwise
to a full stop. DO NOT use a
wrench to tighten because it could damage
the Quick Coupling Nut and result in a
hazardous
condition.
See Fig.12.
6. Open the tank valve fully (counterclockwise).
Use a soapy water solution to check all
connections
for leaks before attempting
to light
your grill. See "Checking for LP Gas Leaks"
on page 14. If a leak is found, turn the tank
valve off and do not use your grill until the
leak is repaired.
Disconnecting
A Liquid Propane Gas (LP gas)
Tank From Your Grill
1.
2.
Turn the Burner Valves and LP gas tank
valve to the full OFF position. (Turn clockwise
to close.)
Detach the hose and regulator
assembly from
the LP gas tank valve by turning the Quick
Coupling Nut counterclockwise.
Figure 11
LP GAS TANK
TANK HOLDER
Figure 12
SiDE
BURNER
ALREADY
_
KIT
CONNECTED
COUPLING
NUT
CAUTION: When the appliance is not in use, the
gas must be turned off at the supply tank.
Congratulations
Your Kenmore
LP gas grill is now ready for
use. Before the first use and at the begin-
ning of each season (and whenever the LP
gas tank has been changed):
1. Read all safety, lighting and operating
instructions.
2. Check Gas Valve Orifices, Burner Tubes
and Burner Ports for any obstructions.
3. Perform gas leak check according to
instructions
found on page 14 of this
manual.
13
Advertisement
