Advertisement
Ignitor Battery Installation
- See Fig. 8
1. Unscrew the Ignitor Cap located on the grill
Control Panel and remove the Contact and
Spring from the Ignitor Slot.
2.
Place the manufacturer
supplied
AA battery
into the Ignitor Slot. Be sure to place the
positive pole facing toward you. See Fig. 8.
3.
Place the Spring over the AA battery, then
place the Contact on top of the Spring.
Screw the Ignitor Cap back onto the grill
Control Panel.
4.
Remove any protective film from outside and
inside of Grill Head.
.
If no "clicking"
sound is heard check the
following
common
causes. If you need assis-
tance call our Customer Service
Helpline
at 1-888-317-7642.
Ignitor AA battery not installed properly.
Ignitor wires may be loose. Remove the AA battery,
inspect the Ignitor Junction Box found behind the
Control Panel, and connect any loose wires.
Figure 8
Electrode Check - Requires
an Assistant
Before placing the cooking components into your
grill, ensure that the Spark Electrode Tip is prop-
eriy positioned within each Gas Collector Box (a
3-1/4" wide stainless mechanism found at the front
between each set of Burners.) The easiest way to
ensure this is to perform this Electrode Check:
1. Be sure all Control Knobs are set to "OFF"
and open the Grill Lid.
2.
Have an assistant stand behind to the right of
the grill and look down at each Gas Collector
Box. NEVER put your face inside Grill Head.
3.
Press the Ignitor Cap. You should hear a
"clicking" sound and your assistant
should see
a small blue spark within each Gas Collector
Box. If a spark is present the Electrode
Tips
are properly
positioned.
4.
If no spark is seen the Spark Gap shown in
Fig. 9 needs to be adjusted as follows:
Using an adjustable wrench, loosen the Inside Nut
just until the Gas Collector Box can be maneuvered
and turned upward.
The gap between the Spark Electrode Tip and
Spark receiver should be approximately 3/16".
If the gap is wider than 3/16" use a pair of long
nose pliers and gently squeeze the Gas Collector
Box until the gap is correct.
Return the Gas Collector Box to its original horizon-
tal position, secure the Inside Nut and try the
Electrode Check again.
AA BATTERY
IGNITOR CAP
"_'f
SPRING
CONTACT
Figure 9 - Side View Figure
GAS COLLECTOR
BOX
SPARK
RECEIVER
SLOT
12
Advertisement
