Problem With The Link Quality; Problems Communicating With Other Computers; Table 22 Troubleshooting Link Quality; Table 23 Troubleshooting Communication Problem - ZyXEL Communications G-202 User Manual

ZyXEL G-202 User's Guide

7.3 Problem with the Link Quality

Table 22 Troubleshooting Link Quality

PROBLEM
The link quality
and/or signal
strength is poor all
the time.

7.4 Problems Communicating With Other Computers

Table 23 Troubleshooting Communication Problem

PROBLEM
In wireless station
mode, the
computer with the
G-202 installed
cannot
communicate with
the other
computer(s).
In access point
mode, the wireless
station(s) cannot
associate to the G-
202.
84
CORRECTIVE ACTION
Search and connect to another AP with a better link quality using the Site Survey
screen.
Move your computer closer to the AP or the peer computer(s) within the
transmission range.
There may be too much radio interference (for example microwave or another AP
using the same channel) around your wireless network. Lower the output power of
each AP.
Make sure there are not too many wireless stations connected to a wireless
network.
CORRECTIVE ACTION
In Infrastructure Mode
• Make sure that the AP and the associated computers are turned on and
working properly.
• Make sure the G-202 computer and the associated AP use the same SSID.
• Change the AP and the associated wireless clients to use another radio
channel if interference is high.
• Make sure that the computer and the AP share the same security option and
key. Verify the settings in the Profile Security Setting screen.
• If you are using WPA(2) or WPA(2)-PSK security, try changing your encryption
type from TKIP to AES or vice versa.
In Ad-Hoc (IBSS) Mode
• Verify that the peer computer(s) is turned on.
• Make sure the G-202 computer and the peer computer(s) are using the same
SSID and channel.
• Make sure that the computer and the peer computer(s) share the same
security settings.
• Change the wireless clients to use another radio channel if interference is high.
Verify that the computer with the G-202 installed is turned on.
Make sure the wireless station(s) uses the same SSID as the G-202.
Make sure the wireless station(s) uses the same security settings.
Verify that the wireless station(s) is not blocked in the MAC Filter screen.
Chapter 7 Troubleshooting