Handlebar Switches - Yamaha Majesty YP400V Owner's Manual

INSTRUMENT AND CONTROL FUNCTIONS
Clock mode
To set the clock:
1. Push the "SELECT" button and
"RESET" button together for at
1 least two seconds.
2. When the hour digits start flashing,
push the "RESET" button to set the
2
hours.
3. Push the "SELECT" button, and
3
the minute digits will start flashing.
4. Push the "RESET" button to set
the minutes.
4
5. Push the "SELECT" button and
then release it to start the clock.
5
Pushing the "SELECT" button for
at least two seconds switches the
6
clock display to the ambient tem-
perature display.
7
Ambient temperature display
This display shows the ambient tem-
8
perature from –10 °C (14 °F) to 50 °C
(122 °F) in 1 °C or 1 °F increments. The
9
temperature displayed may vary from
the ambient temperature. Pushing the
"SELECT" button for at least two sec-
onds switches the ambient temperature
display to the clock display.
NOTE:
G
If the ambient temperature falls be-
low –10 °C (14 °F), a lower tem-
perature than –10 °C (14 °F) will
not be displayed.
G
If the ambient temperature climbs
above 50 °C (122 °F), a higher
temperature than 50 °C (122 °F)
will not be displayed.
G
The accuracy of the temperature
reading may be affected when
riding slowly (approximately under
20 km/h (12.5 mi/h)) or when
stopped at traffic signals, railroad
crossings, etc.
3-6

Handlebar switches

Left
1
2
3
1. Dimmer switch " / "
2. Turn signal switch " / "
3. Horn switch " "
EAU12343