Inspecting And Replacing Anode(S) - Yamaha 115 Owner's Manual

Maintenance
been drained. If the oil is milky, water
is getting into the gear case which
can cause gear damage. Consult a
Yamaha dealer for repair of the lower
unit seals.
[ECM00711]
TIP:
For disposal of used oil, consult your
Yamaha dealer.
5. Put the outboard motor in a vertical po-
sition. Using a flexible or pressurized fill-
ing device, inject the gear oil into the
gear oil drain screw hole.
Recommended gear oil:
Hypoid gear oil SAE#90
Gear oil quantity:
0.760 L (0.803 US qt, 0.669 Imp.qt)
6. Put a new gasket on the oil level plug.
When the oil begins to flow out of the oil
level plug hole, insert and tighten the oil
level plug.
Tightening torque:
9 Nm (0.9 kgf-m, 6.6 ft-lb)
7. Put a new gasket on the gear oil drain
screw. Insert and tighten the gear oil
drain screw.
Tightening torque:
9 Nm (0.9 kgf-m, 6.6 ft-lb)
66
EMU29312

Inspecting and replacing anode(s)

Yamaha outboard motors are protected from
corrosion by sacrificial anodes. Inspect the
external anodes periodically. Remove scales
from the surfaces of the anodes. Consult a
Yamaha dealer for replacement of external
anodes.
ECM00720
NOTICE
Do not paint anodes, as this would render
them ineffective.
TIP:
Inspect ground leads attached to external
anodes on equipped models. Consult a
Yamaha dealer for inspection and replace-
ment of internal anodes attached to the pow-
er unit.
ZMU03274
ZMU01901
ZMU03461