Table of Contents
Advertisement
Operation
6.
After the engine starts, slowly return the
manual starter handle to its original po-
sition before releasing it.
NOTE:
When the engine is cold, it needs to be
G
warmed up. For further information, see
page 33.
If the engine does not start on the first try,
G
repeat the procedure. If the engine fails to
start after 4 or 5 tries, open the throttle a
small amount and try again. Also if the en-
gine is warm and fails to start, open the
throttle a small amount and try to start the
engine again. If the engine still fails to
start, see page 59.
EMU27642
Electric start / remote control models
1.
Place the remote control lever in neutral.
NOTE:
The start-in-gear protection device prevents
31
the engine from starting except when in neu-
tral.
2.
Attach the engine stop switch lanyard to
a secure place on your clothing, or your
arm or leg. Then install the lock plate on
the other end of the lanyard into the en-
gine stop switch.
EWM00120
WARNING
ZMU03008
Attach the engine stop switch lanyard
G
to a secure place on your clothing, or
your arm or leg while operating.
Do not attach the lanyard to clothing
G
that could tear loose. Do not route the
lanyard where it could become entan-
gled, preventing it from functioning.
Avoid accidentally pulling the lanyard
G
during normal operation. Loss of en-
gine power means the loss of most
steering control. Also, without engine
power, the boat could slow rapidly. This
could cause people and objects in the
boat to be thrown forward.
3.
Turn the main switch to "
" (on).
Advertisement
Table of Contents
