Table of Contents
Advertisement
a secure place on your clothing, or your
arm or leg. Then install the lock plate on
the other end of the lanyard into the en-
gine stop switch.
EWM00120
WARNING
Attach the engine stop switch lanyard
G
to a secure place on your clothing, or
your arm or leg while operating.
Do not attach the lanyard to clothing
G
that could tear loose. Do not route the
lanyard where it could become entan-
gled, preventing it from functioning.
Avoid accidentally pulling the lanyard
G
during normal operation. Loss of en-
gine power means the loss of most
steering control. Also, without engine
power, the boat could slow rapidly. This
could cause people and objects in the
boat to be thrown forward.
3.
Open the throttle slightly without shifting
using the neutral throttle lever. You may
need to change the throttle opening
slightly depending on engine tempera-
ture. After the engine starts, return the
throttle to the original position.
NOTE:
As a starting point, lift the lever just until
G
you feel resistance, then lift slightly more.
The neutral throttle lever can only be used
G
when the remote control lever is in neutral.
4.
Pull out / turn the choke knob fully. After
the engine starts, replace / return the
knob to the home position.
ZMU03088
NOTE:
It is not necessary to use the choke when
G
starting a warm engine.
If the choke knob is left in the "
G
(start) position while the engine is running,
the engine will run poorly or stall.
5.
Pull the manual starter handle slowly un-
til you feel resistance. Then give a
strong pull straight out to crank and start
the engine. Repeat if necessary.
Operation
N
ZMU03200
ZMU03717
"
30
Advertisement
Table of Contents
