Maintenance; Periodic Maintenance; Daily/Regular Maintenance - Windsor Cadet CDT7IHB Operator Instructions Manual

Table of Contents

Advertisement

MAINTENANCE

PERIODIC MAINTENANCE

Twice a month, flush a white vinegar solution
(One quart vinegar to two gallons of water) or
anti-browning solution (mixed as directed)
through the extractor. This will prevent build-up
of alkaline residue in the system. If spray jets
become clogged, remove the spray tips, wash
them thoroughly, and blow-dry.
NOTE: Do not use pins, wire, etc. to clean
nozzles as this could destroy spray pattern.
Periodically inspect all hoses, electrical cables
and connections on your machine. Frayed or
cracked hoses should be repaired or replaced
to eliminate vacuum or solution pressure loss. If
the cable insulation is broken or frayed, repair
or replace it immediately. Don't take chances
with electrical fire or shock.
4-1
DAILY / REGULAR MAINTENANCE
Before making any adjustments or repairs to
the machine, disconnect the power cord from
electrical source.
1. Empty unused cleaning solution from the
2. Inspect and clean filter screen in solution
3. Flush pumping system with 4 or 7 liters of
4. After each use, rinse tank with fresh water.
5. Check for and remove any lint or debris
6. Check spray jets for full spray pattern.
7. Remove lint and dirt build-up from brush
8. Check cooling air screen (located on frame
9. Check float and shut-off screen and clean
NOTE: Always store machine with brush in
"Store" position.
CDT7IHB 86036840 03/12/07
solution tank.
tank.
clean, hot water.
Periodically inspect the recovery tank and
decontaminate if necessary, using a
Hospital Grade Virucide or a 1-10 bleach to
water solution. Waste water should be
disposed of properly.
around vac shoe.
and housing.
NOTE: Brush removal.
A. To remove brush, grab and pull brush
out from end opposite drive belt
(operator's right). Remove other end
from brush driver.
B. To install brush, line up slots in brush
core with pin in driver on drive belt side
(operator's left) and push brush onto
driver. Then snap bearing end (opposite
end) of brush into retaining clip.
behind left wheel) for lint or debris.
as necessary.

Advertisement

Table of Contents
loading

This manual is also suitable for:

10080240

Table of Contents