A&D SK-5000 Instruction Manual page 4

PREPARATION
1. Installing batteries / Connecting the AC adapters
Batteries
When replacing batteries, be careful not to apply too much force
to the weighing pan. An excessive force could damage the scale.
AC adapter (optional)
2. Setting up the SK
Avoid installing the scale in direct sunlight, that may cause
discoloration or malfunctions. Place your SK on a firm weighing
table so that the scale is level. (The scale will not perform
accurately when it is not level.)
Place the SK on the firm surface so that the sprit level shows that
the scale is leve for an accurate weighing.
CAUTION
Remove the battery compartment
cover and insert six batteries
(R20P/LR20/D size) into the
battery
extreme care that the polarities
plus and minus are observed.
Plug the AC adapter to the AC
adapter
battery compartment.
The AC input requirement could
be 100, 120, 220, 230, or
240Volts (50/60Hz) depending
on the area where used, so
please verify that the adapter is
correct.
CAUTION
- 3 -
compartment,
socket inside
taking
the