Table of Contents
Advertisement
Product support
wood
, block(a)
A solid soffit or a wood block is
required to prevent the refrigerator
from tipping forward after it is
installed.
Determine what height the
refrigerator will be when it is
installed to fit opening. Determine
the height to the top of the cover at
the final installed height you plan
to use.
!/I
l\\\\\lj/fl
Block(s) ml'*t
be lorig.enough
to fully cover
wldth of cover.
-Important:
El&k(s) &,t
..--_
0
It
extend et least 2"
over cover.
. f.
cover
, wood block(s)
Personal Injury/Property
Damage Hazard
The solld soffit must be no
more than 1" (25 mm) above
the cover or you will need to
attach a wood block to the wall.
Fallure to attach wood blocks
to the wall could result In
personal Injury or property
damage.
l offlt -
(more than 1"
(25 mm) above
cover)
rofflt-
r12eimfi;n 1"
above cover)
,114" (6 mm)
- max.
\ cover
\
rear wall
Your installation location may vary
from the examples shown. However,
you must support the refrigerator
with a wood block or other adequate
means of support located l/4"
(6 mm) above the cover.
Locate wood block.
a mexlmum of l/4"
When a sofflt Is not avallable,
locate wall studs in the refrigerator
opening. Center one wood block
and use wood screws to attach the
wood block to the wall studs. Make
sure screws engage wall studs a
minimum of 1 -l/2" (38 mm). Screw
the second wood block to the front
of the first block. The wood blocks
must extend 2 inches (51 mm)
beyond the ends of the cover.
- cover
\ re r wall
If soffit Is less than one Inch
(25 mm) above cover, a wood
support is not needed.
If soffit Is more than one inch
(25 mm) above cover, locate wall
studs in the refrigerator opening.
Center one wood block and use
wood screws to attach the wood
block to the wall studs. Make
sure screws engage wall studs a
minimum of 1 -l/2" (38 mm). Screw
the second wood block to the front
of the first block. The wood block(s)
must extend 2 inches (51 mm)
beyond the ends of the cover.
Page 7
Advertisement
Table of Contents
