Pace DC700X Operator's Manual page 27

Hide thumbs Also See for DC700X:

Table of Contents

MAKING USER SETTINGS (cont.)

Changing the TV Display Capability

If you have not already done so, put your set-top into User Settings mode, as described on page 22.

1. Press the U or D button on your remote control and highlight TV Display Capability on the PACE USER

SETTINGS menu.

2. Press the R button. The TV Display Capability menu, shown right, appears on your TV screen.

3. Press the U or D button to highlight each resolution in turn on the menu and, for each one, press the

SELECT button if you wish to change the setting (the setting changes between "YES" and "NO" each time you

press SELECT).

The available resolutions are: 1080i, 720p, 480p, and 480i. (See page 24 for more information about these.)

If, at any stage in this process, the menu disappears from the screen, immediately press the

SELECT button to restore the menu.

4. When you are satisfied that all the TV resolutions are correct, press the L button. The PACE USER SETTINGS

menu reappears.

To continue making the settings, see page 26.

Further information about the TV Display Capability

The TV Display Capability settings relate to equipment that is connected to the HDMI and COMPONENT VIDEO

connectors because the settings control the output at those connectors. If equipment is connected via an HDMI

cable, that equipment may also pass information back to your set-top, which may affect what settings are

available.

Generally, the TV Display Capability settings do not affect equipment connected to the VIDEO OUT connector,

because the output at this connector is always standard definition 480i.

If the display resolution is currently set,

the MESSAGE light is lighted and YES

is on the menu

TV Display Capability

1080i : YES

720p

: NO

480p

: YES

480i

: YES

Table of Contents