Table of Contents
Advertisement
3.
Align dimple of middle pole with slot of bottom pole. While maintaining alignment, bounce
top and middle pole assembly (1 & 2) onto lower pole section (3) as shown until they no
longer move toward pole identification mark.
CAUTION!
THE IDENTIFICATION STICKER IS
LOCATED 5" FROM THE END OF
THE POLE. WHEN PROPERLY
POUNDED TOGETHER, THE POLE
SECTIONS SHOULD HAVE A 3-1/2"
MINIMUM OVERLAP, LEAVING 1-
1/2" BETWEEN THE OVERLAPPING
POLE AND THE IDENTIFICATION
STICKER.
3-1/2" (9 CM) MINIMUM
IDENTIFICATION
MARK
P/N 21147703 03/04
NOTE:
POLE SECTIONS
SHOULD HAVE A
OVERLAP.
POLE
WOOD SCRAP
(NOT SUPPLIED)
1
2
3
10
2
Bottom Pole
IDENTIFICATION
STICKER
2
IDENTIFICATION
Bottom Pole
STICKER
RODS SHOWN ARE
FOR VISUAL
REPRESENTATION
OF ALIGNMENT
AND ARE NOT
SUPPLIED WITH
THE HARDWARE
IMPORTANT!:
Holes in top (1) and bottom
pole (3) sections MUST
align to correctly position
elevator system toward
playing surface.
5"
3
1-1/2"
3
Advertisement
Table of Contents
