Huffy 211387 Owner's Manual

Huffy 211387 Owner's Manual

Portable basketball system

Advertisement

Quick Links

A Huffy Company

SAFETY INSTRUCTIONS

FAILURE TO FOLLOW THESE SAFETY INSTRUCTIONS MAY RESULT IN
SERIOUS INJURY, PROPERTY DAMAGE AND WILL VOID WARRANTY.
Owner must ensure that all players know and follow these rules for safe
To ensure safety, do not attempt to assemble this system without following the
instructions carefully. Proper and complete assembly, use and supervision is
essential for proper operation and to reduce the risk of accident or injury. A high
probability of serious injury exists if this system is not installed, maintained, and
operated properly. Check entire box and inside all packing material for parts
and/or additional instructional material. Before beginning assembly, read the
instructions and identify parts using the hardware identifier and parts list in this
document.
• If using a ladder during assembly, use extreme caution.
• Two (2) people are recommended for this operation.
• Check base regularly for leakage. Slow leaks could cause system to tip over
unexpectedly.
• Seat the pole sections properly (if applicable). Failure to do so could allow the pole
sections to separate during play and/or transport of the system.
• Climate, corrosion or misuse could result in system failure.
• If technical assistance is required, contact the manufacturer.
• Minimum operational height is 6'6" (1.98 m) to the bottom of backboard.
• This equipment is intended for home recreational use only and NOT
excessive competitive play.
• Read and understand the warning label affixed to pole. Label is shown on page 2.
• The life of your basketball pole depends on many conditions. The climate,
placement of the pole, the location of the pole, exposure to corrosives such as
pesticides, herbicides or salts are all important.
• If technical assistance is required, contact Huffy Sports.
• Adult supervision is recommended when adjusting height.
Most injuries are caused by misuse and/or not following instructions.
For more information on assembly, placement, proper use and maintenance, visit
The American Basketball Council website at http://www.smarthoops.com.
In U.S. and Canada only:
We appreciate your purchasing one of our many fine products. We are sure that you will be very satisfied with your selection. Although
great care and effort have been taken, occasionally problems may occur. To ensure prompt and correct handling of any problems, or to
answer any questions, please contact our Toll-Free Customer Service Number listed below. Service will be quicker if you have your
Model Number (found on carton) and assembly instructions ready when calling. PLEASE WRITE YOUR MODEL NUMBER IN
THE SPACE PROVIDED ABOVE.
Toll-Free Customer Service Number for U.S: 1-800-558-5234
printed on recycled paper
WRITE IN YOUR MODEL NUMBER:
Portable Basketball System
Owners Manual
operation of the system.
Use caution when using this system.
Have questions...don't go back to the store!
Internet Address: http://www.huffysports.com
___________
• Two People
• Wood Board (Scrap)
• Tape Measure
• Step Ladder 8 ft. (2.4 m)
• Tape
1
Customer Service Center
N53 W24700 South Corporate Circle
Sussex, WI 53089
U.S.A.
REQUIRED TOOLS AND
MATERIALS:
• Water or Sand 360 lb.
(163 kg)
• Hammer
• Wrench: 1/2"
• Support Table
Canada Only: 1-800-284-8339
5/99
P/N 211387

Advertisement

Table of Contents
loading

Summary of Contents for Huffy 211387

  • Page 1: Safety Instructions

    REQUIRED TOOLS AND • If technical assistance is required, contact Huffy Sports. MATERIALS: • Adult supervision is recommended when adjusting height.
  • Page 2 (Do not use salt.) • Use extreme caution if placing system on sloped surface. 201259 3/99 System may tip over more easily. In the U.S.:1-800-558-5234 and Canada: 1-800-284-8339 201241 2/99 printed on recycled paper P/N 211387 5/99...
  • Page 3 (8), adjustment knob (9), and flange nut (13). IMPORTANT! This step MUST be completed before going on to step 5. “Bottom of middle “Top of upper pole section” pole section” NOTE: Top pole section will slide through middle pole section. printed on recycled paper 5/99 P/N 211387...
  • Page 4 Once assembled, pole sections can NOT be separated! POLES MUST OVERLAP 3-1/2” (9 CM) MINIMUM. NOTE: Discard this carriage bolt immediately after completing this step. DO NOT discard flange nut and washer. WOOD SCRAP printed on recycled paper P/N 211387 5/99...
  • Page 5 Place tank (1) in desired location. Fill tank (1) with water (30 gallons (114 liters)) or sand (360 lb. (163 kg)). Snap tank cap (18) in place. IMPORTANT! Add two gallons (7.6 liters) of NON-TOXIC ANTIFREEZE in sub-freezing climates. printed on recycled paper 5/99 P/N 211387...
  • Page 6 Attach upper pole mounting bracket (20) to swivel bracket (21) and fully tighten. Attach lower halves of backboard brackets (23) to swivel bracket (21). NOTE: Keep hardware loose until after alignment in step 16. printed on recycled paper P/N 211387 5/99...
  • Page 7 Attach back bracket (26) to backboard and backboard brackets (23) as shown and finger tighten. NOTE: Do NOT tighten completely. Final adjustments will be made in step 24. printed on recycled paper 5/99 P/N 211387...
  • Page 8: Outside View

    Install net (35). INSIDE VIEW NOTE: Stretching net up then pulling side to IMPORTANT! MAKE side will help snap net SURE NET IS HELD BY under center hook. ALL THREE HOOKS ON THE NET CLIP. printed on recycled paper P/N 211387 5/99...
  • Page 9 NOTE: Two people recommended for this procedure. Level backboard 10 feet (3.05 m) and rim adjust hardware from step 13 and 16. Tighten completely. Apply height adjustment label (40) to front of pole as shown. printed on recycled paper 5/99 P/N 211387...
  • Page 10 Remove adjustment knob (24) from swivel bracket (21) and carefully rotate backboard assembly 180º. PLAY POSITION STORAGE POSITION Secure backboard assembly in storage position with adjustment knob set (24 and 8) as shown. printed on recycled paper P/N 211387 5/99...
  • Page 11 Remove tie down stake (37) from ground and detach rope (36). Rotate system up onto the front wheels and roll toward the wall. Secure system with rope (36) on screw hook (39). printed on recycled paper 5/99 P/N 211387...
  • Page 12: Parts List

    HARDWARE IDENTIFIER Item #7 (4) Item #12 (11) Item #8 (11) Item #17 (2) Item #15 (2) Item #13 (23) Item #19 (1) Item #22 (1) YOU MAY HAVE EXTRA PARTS WITH THIS MODEL. printed on recycled paper P/N 211387 5/99...
  • Page 13 HARDWARE IDENTIFIER (continued) Item #27 (6) Item #34 (12)* Item #29 (1) Item #31 (2) Item #30 (1) Item #38 (1) Item #39 (1) printed on recycled paper 5/99 P/N 211387...

Table of Contents