Toshiba DVR D-R17DTKB Owner's Manual page 21

E7J70BD_EN.book Page 21 Monday, May 7, 2007 3:31 PM
Note
• Because HDMI is an evolving technology, it is
possible that some devices with an HDMI input may
not operate properly with this unit.
• When using an HDCP-incompatible display device,
the image will not be viewed properly.
• Among the devices that support HDMI, some
devices can control other devices via the HDMI
connector; however, this unit cannot be controlled
by another device vice the HDMI connector.
• The audio signals from the HDMI connector
(including the sampling frequency, the number of
channels and bit length) maybe limited by the device
that is connected.
• Among the monitors that support HDMI, some do
not support audio output (for example, projectors).
In connections with device such as this unit, audio
signals are not output from the HDMI output
connector.
• When this unit's HDMI connector is connected to a
DVI-D compatible monitor (HDCP compatible) with
an HDMI-DVI converter cable, the signals are output
in digital RGB.
• If the connected equipment is not compatible with
HDMI BITSTREAM, DTS sound will not be output.
• When the power failure occurs, or when you unplug
the unit, some problems in the HDMI setting might
occur.
Please check and set the HDMI setting again.
Connecting to External Equipment
This unit has three input terminals, AV1 or AV2 on the
rear panel and AV3 on the front panel. Be sure that all
the units are off before making connections.
Recording from a DVD player, Satellite Box
or other Audio-Video equipment with a Scart
output socket (AV2)
Scart cable (not supplied)
AV2 (DECODER)
COAXIAL
IN
DIGITAL AUDIO OUTPUT
PCM/BITSTREAM
Y
HDMI OUT
L
P B /C B
R
OUT P /C
R R
AV2 (DECODER)
DVB-T ANALOG
COMPONENT ANALOG
ANTENNA VIDEO OUTPUT AUDIO OUT
Note
• When you record a TV programme from a Satellite
Box, you must connect a Scart cable to
AV2(DECODER). (See page 42.)
• When AV2 is connected, the signal from the AV2 will
be output automatically. If you want to monitor the
signal from other input, you must press [DISPLAY]
first. Then, select the desired input to monitor with
[INPUT SELECT ].
Recording from a camcorder or other
Audio-Video equipment with no Scart output
socket (AV3)
If no S-Video input jack is available, connect to
VIDEO input jack on the front panel using an RCA
Video cable.
Change the setup when using S-VIDEO input jack.
(See page 44.)
AV3 (Front)
1080p 1080i 720p 576p/480p
STOP PLAY REC
AV3
S-VIDEO VIDEO
S-Video cable
(not supplied)
S-VIDEO AUDIO
OUT OUT
AV output jack
(Scart)
AV1 (TV)
L R
Audio cable
(not supplied)
21
EN