Toshiba DVR D-R17DTKB Owner's Manual page 24

E7J70BD_EN.book Page 24 Monday, May 7, 2007 3:31 PM
Auto Tuning (ANALOG)
ANALOG
Programme the tuner to scan only the channels you
can receive in your area.
1
In stop mode, press [SETUP]. Select
"General Setting" using [U / D],
then press [ENTER/OK].
General Setting Menu will appear.
2
Select "Channel" using [U / D], then
press [ENTER/OK].
3
Select "ANALOG Channel Setup"
using [U / D], then press
[ENTER/OK].
4
Select "Auto Tuning" using [U / D],
then press [ENTER/OK].
The unit will start storing channels available in
your area.
General Setting
Playback
Display
Video
Recording
ANALOG Channel Setup
Clock
Auto Tuning
Channel
Manual Tuning
DivX
Move
HDMI
Reset All
Wait for several minutes to finish channel storing.
• Analogue channels will be stored in channel
901-999 after it is scanned by this unit.
5
Press [SETUP] to exit.
You can select only the channels memorised in
this unit by using [PROG.
To cancel auto tuning
Press [RETURN/BACK] or [SETUP] during scanning.
Note
• The selection will be affected by how you receive TV
channels in your local area.
• If the auto tuning is cancelled during scanning,
some channels not yet tuned may not be received.
• You cannot change the channel when DVD is in any
recording mode (normal recording, One-touch Timer
Recording or timer recording).
24
EN
Auto Tuning (DVB & ANALOG)
DVB Channel Setup
ANALOG Channel Setup
/ ].
Manual Tuning (ANALOG)
ANALOG
You can preset an analogue channel manually and
individually.
1
In stop mode, press [SETUP]. Select
"General Setting" using [U / D],
then press [ENTER/OK].
2
Select "Channel" using [U / D], then
press [ENTER/OK].
3
Select "ANALOG Channel Setup"
using [U / D], then press
[ENTER/OK].
4
Select "Manual Tuning" using
[U / D], then press [ENTER/OK].
5
Select "Position" using [U / D], then
press [P].
Manual Tuning
Position 901
Channel
Decoder OFF
Skip ON
6
Select the position number you wish
to use using [the Number buttons] or
[U / D], then press [L].
• You can select position number 901-999.
• With [the Number buttons], you only need to
enter the last 2 digit numbers.
7
Select "Channel" using [U / D], then
press [P].
8
Press [U / D] to start scanning.
• The tuner will begin to search up or down
automatically. When a channel is found, the unit
will stop searching and the picture will appear
on the TV screen.
• You can select a desired channel number using
[the Number buttons]. Refer to the following
Channel Plan table and press the three digits to
select the channel number.
(To select channel 4, press [0] first and then
press [0] and [4]. Or press [4] and then "– – 4"
appears and wait for 2 seconds.)
• If this is the channel you want, press [L].
Channel Plan
CH Indication
01 – 10
21 – 69
74 – 78
80 – 99, 100
121 – 141
1
TV Channel
IRA-IRJ, GAP
E21 – E69
X, Y, Z, Z+1, Z+2
S1 – S20, GAP
S21 – S41