Cord Routing Change - Friedrich SS08 Installation Manual

Cord Routing C hange
Unplug unit.
Electrical Shock Hazard
Make sure your electrical receptacle has the
same configuration as your air conditioner's
plug. If different, consult a Licensed Electrician.
Do not use plug adapters.
Do not use an extension cord.
Do not remove ground prong.
Always plug into a grounded 3 prong oulet.
Failure to follow these instructions can result in
death, fire, or electrical shock.
Forconvenience andoptimum appearance the directionthatthe powercord
exitsthe unit maybe changedfrom left to rightbyfollowing the procedure
below. Selectthe exit locationon the left or right based on proximityto
the poweroutlet.
Figure 31
ELECTRICAL
CONTROL PANEL
NOTE:
DECORATIVE FRONT REMOVED USE TOOL PROVIDED.
(SEE FIGURE 29 FOR LOCATION OF TOOL).
FRR054
Remove 3 screws as shown from the electrical control panel. Save to
reinstall later.
Figure 32
ELECTRICAL CONTROL
PANEL SCREWS (3)
FRR055
STEP16. Carefullypullout electricalcontrol panel1",but notall the way.
Figure 33
lINCH
4"
FRR056
STEP17. Pullelectricalcordstrain reliefdownwarduntilfree androtate
90 degrees to the right.
Figure 34
ELECTRICAL CORD
STRAIN RELIEF
FRR057
STEP18. Pushelectricalcordstrainreliefbackupwardintothe electrical
control panel.
Figure 35
/
ENSURE THE ELECTRICAL CORD STRAIN RELIEF IS
FLUSH WITH THE TOP OF ELECTRICAL CONTROL PANEL
FRR058
34