Cord Routing Change - Friedrich Kuhl SM18M30 User Manual

Cord Routing Change

Unplug unit.
WARNING
Electrical Shock Hazard
Make sure your electrical receptacle has the
same configuration as your air conditioner's
plug. If different, consult a Licensed Electrician.
Do not use plug adapters.
Do not use an extension cord.
Do not remove ground prong.
Always plug into a grounded 3 prong oulet.
Failure to follow these instructions can result in
death, fire, or electrical shock.
For convenience and optimum appearance the direction that the power cord
exits the unit may be changed from left to right by following the procedure
below. Select the exit location on the left or right based on proximity to
the power outlet.
Figure 30
ELECTRICAL
CONTROL PANEL
NOTE:
DECORATIVE FRONT REMOVED USE TOOL PROVIDED.
(SEE FIGURE 28 FOR LOCATION OF TOOL).
Remove 3 screws as shown from the electrical control panel. Save to
reinstall later.
Figure 31
ELECTRICAL CONTROL
PANEL SCREWS (3)
30
920-198-00
STEP 15. Carefully pull out electrical control panel 1", but not all the way.
Figure 32
1 INCH
STEP 16. Pull electrical cord strain relief downward until free and rotate
90 degrees to the right.
Figure 33
ELECTRICAL CORD
STRAIN RELIEF
STEP 17. Push electrical cord strain relief back upward into the electrical
control panel.
FRR054
Figure 34
ENSURE THE ELECTRICAL CORD STRAIN RELIEF IS
FLUSH WITH THE TOP OF ELECTRICAL CONTROL PANEL
FRR055
90°
FRR056
FRR057
FRR058