Hunter Thermostat Owner's Manual page 15

Be sure to tighten the terminal screws securely, otherwise a loose wire could cause operational
problems with your system or thermostat.
Push excess wire back into hole to prevent interference with mounting of the thermostat cover.
Make sure the Function Switch is set at OFF, and the FAN-AUTO Switch is in AUTO.
Insert the bottom tab on the thermostat body into the slot at the bottom of the wallplate.
Press top of the thermostat body to snap it into the wallplate. (NOTE: Do not force the
thermostat onto the wallplate, as the terminal pins may be damaged. If it does not
snap properly, the thermostat may not work.)
Insert the two AA size batteries, observing the
polarity marked on the unit.
Switch on the main power. Press the reset button.
(See Figure 5.)
The LCD display indicates the current room
temperature of your house. If it shows random
numbers or partial digits, press the reset button
once again.
The installation is now complete. Continue reading
Owner's Manual for complete operating instructions.
RH
FIGURE 3
RC RH G W Y
FIGURE 4
FIGURE 5