Error Messages; Care And Maintenance - Jensen VM9424BT Operating Instructions Manual

Error Messages

Message
Displayed
Loading Disc is being read
No Disc Disc is dirty
Disc is upside down
Disc not present in loading
compartment
Bad Disc Disc is dirty
Disc is upside down
Unknown Disc format is not compatible
disc with this unit
Region Error DVD is not compatible with
region code of unit
Error Illegal mechanism operation

Care and Maintenance

1. Use only a clean silicone cloth and neutral detergent to clean the front
panel or monitor. A rough cloth and non-neutral detergent (such as alco-
hol) may result in scratching or discoloration.
2. Do not get water or cleaning fluids on the unit.
3. If the temperature inside the player gets too hot, a protective circuit
automatically stops play of the disc. If this occurs, allow the unit to cool
before operating the player again.
4. Never insert anything other than a 5" (12 cm) compact disc into the player
as the mechanism can be damaged by foreign objects.
5. Do not attempt to use a 3" (8 cm) CD-Single disc in this unit, either with or
without an adaptor, as damage to the player and/or disc may occur. Such
damage is not covered by the Warranty on this product.
6. The CD player may not operate properly in extreme hot or cold. If such
conditions occur, allow the interior of the vehicle to reach a normal
temperature before using player.
7. When the vehicle warms up during cold weather or under damp
conditions, condensation may appear on the LCD panel. Should this
occur, the screen will not operate properly until the moisture has
evaporated.
Table 10: Error Messages
Cause
56
Corrective Action
Clean disc with soft cloth
Insert disc with label side up
Insert disc
Clean disc with soft cloth
Insert disc with label side up
Press EJECT key for 5 seconds to
reset loading mechanism
VM9424BT