Jensen VM9424 Installation Manual
  1. Manuals
  2. Brands
  3. Jensen Manuals
  4. Car Video System
  5. VM9424
  6. Installation manual

Jensen VM9424 Installation Manual

Jensen car video system installation guide
Hide thumbs Also See for VM9424:
1
2
3
4
Table of Contents

Advertisement

Quick Links

What's in the Box
VM9424 Head Unit
Left and Right Double DIN
Mounting Brackets
Double DIN Half Sleeve Install Bracket
Remote Control with Battery
Two Custom Cosmetic Trim Rings
Parking Brake Wire
Hardware Bag
Speaker Output Harness
Power Input Harness
2 x Accessory Harness
Installation Guide
WARNING! Never install this unit where operation and viewing could interfere with
safe driving conditions.
VM9424
You will need these tools and supplies to
install your VM9424:
•
•
•
•
•
•
•
•
•
1
Installation Guide

Tools and Supplies

Torx type, fl at-head and Philips
screwdrivers
Wire cutters and strippers
Tools to remove existing radio (screw
driver, socket wrench set or other tools)
Electrical tape
Crimping tool
Volt meter/test light
Crimp connections
18 gauge wire for power connections
16 – 18 gauge speaker wire

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the VM9424 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for Jensen VM9424

Summary of Contents for Jensen VM9424

  • Page 1: Tools And Supplies

    VM9424 What’s in the Box VM9424 Head Unit Left and Right Double DIN Mounting Brackets Double DIN Half Sleeve Install Bracket Remote Control with Battery Two Custom Cosmetic Trim Rings Parking Brake Wire Hardware Bag Speaker Output Harness Power Input Harness...

  • Page 2: Optional Equipment

    To prevent a short circuit, be sure to turn off the ignition and remove the negative (-) battery cable prior to in- stallation. NOTE: If the VM9424 is to be installed in a car equipped with an on-board drive or navigation computer, do not disconnect the battery cable. If the cable is disconnected, the computer memory may be lost. Under these conditions, use extra caution during installation to avoid causing a short circuit.
  • Page 3 Installation Using Half-Sleeve Install half-sleeve in the dashboard. Install adapter if necessary (optional). Install half-sleeve into adapter or dashboard (use only the supplied screws). Do not force the sleeve into the opening or cause it to bend or bow. WARNING! Only connect the unit to a 12-volt power supply with proper grounding.

This manual is also suitable for:

Vm9424bt

Table of Contents