Using The Tft Monitor; Standby Mode; Picture Adjustment; Parking Brake Inhibit - Jensen VM9424BT Operating Instructions Manual

USING THE TFT MONITOR

Standby Mode

Touch the STANDBY button on the Source Menu and then screen becomes
black. Touch the screen to resume normal video display.
To access the Source menu, touch the top left corner of the screen or press
the SRC button on the front panel (10) or remote control (8).
Radio
BLUETOOTH

Picture Adjustment

To adjust monitor display settings, perform the following steps:
1. Press the PIC button (24) on the remote control to view the "Picture
Menu".
2. Rotate the VOL button (5) on the front panel to adjust the brightness level
from 0 (least bright) to 20 (most bright).
3. Wait 5 seconds, or press the PIC button (24) on the remote control to exit
the picture menu.

Parking Brake Inhibit

When the pink "PARKING" wire is connected to the vehicle Parking Brake
circuit, the front TFT monitor will display video when the Parking Brake is
engaged. (When the pink wire is grounded via the Parking Brake circuit, video
will be displayed.)
ST DX
N
W E
S
NAVI RADIO CD/DVD
AV2 AV1
BACK
SD USB
CAMERA SETUP
3:02AM STANDBY
8
VM9424BT
2:04AM
XM
REAR